We have 2 x APC Smart UPS 2200VA units at different sites. We have installed 2 x 9630 Network Management cards in them and connected them to the switch at the appropriate site. Using the APC IP Configuration tool, it does detect the network cards as unconfigured and offers the ability to enter the IP address settings. I can enter IP, subnet and default gateway and select OK.
At this point everything seems ok, however the settings are not applied to the card as I cannot ping the new address, nor connect via web browser. If I run the wizard again, it sees it as an unconfigured device again. Download Software Kaspersky (reset Trial). I have tried connecting to both devices via the APC serial cable from different computers and it will not communicate. W7lxe.exe ?. I have also tried different APC cables in case it was that. We have tried this on both devices at both sites.
HELP apc device ip configuration wizard 4 Configure or reconfigure the TCP/IP settings locally To configure a single Network Management Card through a serial. Jul 15, 2011 Device IP Config Wizard. Drug Protein Interaction Pdf. To put an Network Management Card AP9619 in a SURT3000. To configure it I download Device IP Configuration Wizard software from APC site.
The UPS devices were procured at different times as were the network cards so I would find it hard to believe that they are faulty. Any ideas greatly appreciated as I am tearing out what is left of my hair!